Assigning names to the sources – Инструкция по эксплуатации JVC CD Receiver KD-SX947R
Страница 35
35
ENGLISH
3
Select a character.
• See the table below for
available characters.
4
Move the cursor to the next (or
previous) character position.
5
Repeat steps
3 and 4 until you
finish entering the name.
6
Finish the procedure while the last
selected character is flashing.
To erase the entered characters
Insert spaces using the same procedure
described above.
Available characters
Notes:
• When you try to assign a name to the 41st disc,
“NAME FULL” appears on the display. (In this
case, delete unwanted names before assignment.)
• When the CD changer is connected, you can assign
names to CDs in the CD changer. These names can
also be shown on the display if you insert the CDs
in this unit.
Note:
If you change the setting from “TAG
OFF” to “TAG ON” while playing an
MP3 file, the tag display will be
activated when the next file starts
playing.
• TAG OFF:
Turns off the ID3 tag display while
playing MP3 files. (Only the folder
name and file name can be
shown.)
Assigning names to the sources
You can assign names to CDs (both in this unit
and in the CD changer).
After assigning a name, it will appears on the
display when you select the source.
Sources
Maximum number
of characters
CDs*
Up to 32 characters (up to
40 CDs)
* You cannot assign a name to CD Text or an MP3 disc.
1
Select a source you want to assign a
name to.
When you select a source, the power
automatically comes on.
2
While pressing DISP (display), press
and hold SEL (select) for more than
2 seconds.
Ex.: When you select CD as the source
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
space
0
1
2
3
4
5
6
7
8
9
–
/
<
>
CD
CD-CH
EN32-36_KD-SX947R[EE]f.p65
1/10/03, 9:55 PM
35