Troubleshooting – Инструкция по эксплуатации Elenberg PRT-9050
Страница 36
Troubleshooting
36
The following cases may not always be a malfunction, please check suggestions below before ask
ing for service.
Trouble
Analysis
Does not run
If the protector trip or fuse is blown.
Please wait for 3 minutes and start again, pro
tector device may be preventing unit to work.
If batteries in the remote controller exhausted.
If the plug is not properly plugged in.
Runs for a short while only
If the set temperature is close to room temper
ature, you can lower the set temperature.
Air outlet blocked by obstacle.
Take the obstacle away.
Runs but not cooling
If the door or window is open.
If there is another appliance heat working.
like heater or lamp, etc.
The air filter is dirty, please clean it.
Air outlet or intake blocked.
Set temperature is too high.
Water leak during moving
Drain the condensate before moving.
Does not run and water
full indicator lights
Pull out the rubber plug to drain water.
If it is often in this state, please contact quali
fied service technicial.