Elenberg PRT-9050 - Инструкция (Страница 29)

Operation instructions
29
Cooling mode
If you want to cool the room, you can operate the appliance as follows:
1. Press MODE button and select cooling mode.
2. Press FAN button to select the fan speed you need.
3. You also can set the appropriate temperature by using the temperature button.
4. When all the above is done, you can press ON/OFF button to make the appliance run with cool
ing mode.
5. You can adjust the fan direction by pressing swing button, press once for swing, and press again
to stop.
DRY mode
The appliance also gives you the function of drying.
1. Press MODE button and press select dry mode.
2. You can set the appropriate temperature by using the temperature button.
3. Press ON/OFF button to make the appliance run with dry mode.
4. You can adjust the fan direction by pressing SWING button, press once for
swing, and press again to stop.
Note:
Dry mode cannot be used to cool the room.
It requires hot air outlet hose in Dry mode.
In dry mode, fan speed is preset by appliance, so fan button is not appli
cable.
Additional introductions
1. If you select cooling or dry mode while appliance is in another mode, the compressor will be
delay protected. Wait for 3~5 minutes, the appliance will run again. Do not press any button
during the waiting time, or the appliance will re count the protected time.
2. In cooling or dry mode, when the room temperature is up to set the temperature, the compres
sor will stop running, and fan only is at rest.