Elenberg PRT-9050 - Инструкция (Страница 34)

Protection
34
Operating condition
The protective device may trip and stop the appliance in the cases listed below.
If the air conditioner runs in COOLING or DRY mode with door or window opened for a long time
when relative humidity is above 80%, dew may drip down from the outlet.
Features of protector
(1) The protective device will work in the following cases.
•
Restarting the unit at once after operation stops or changing mode during operation, you need
to wait 3 minutes.
• Connect to power supply and turn on the unit at once, it may start 20 seconds later.
(2) If the plug is taken out, when you restart the appliance, it will return to the original mode,
TIMER ON and TIMER OFF must be set again,
drain water
In COOLING or DRY operation, it is possible that water full indicator(red) lights. Please cut off the
power supply, move the appliance to a suitble place to pull out the water plug and drain the water.
After this, be sure to re install the plug, or the appliance may leak and make your room wet.
If the appliance is placed in a position admitting drain water, you also can connect the drain hose
to the drain port to drain water.
COOLING Outdoor air temperature is over *43°C (109°F)
Room temperature is below
18°C (64°F)
DRY Room temperature is below 18°C (64°F)