Elenberg DW-9205 - Инструкция (Страница 36)

36
Electrical connection
After making sure that the voltage and the frequency values for the
current in the home correspond to those on the rating plate and that
the electrical system is sized for the maximum voltage on the rat-
ing plate, insert the plug into an electrical socket which is earthed
properly. If the electrical socket to which the appliance must be
connected is not appropriate for the plug, replace the socket, rather
than using an adaptors or the like as they could cause overheating
and burns.
Cold Water Connection
Connect the cold water supply hose to a
threaded 3/4 (inch) connector and make sure
that it is fastened tightly in place.
If the water pipes are new or have not been
used for an extended period of time, let the
water run to make sure that the water is clear
and free of impurities. If this precaution is not taken, there is a risk
that the water inlet can get blocked and damage the appliance.
Hot Water Connection
The water supply to the appliance can also be connected to the
house hot water line (centralized system, heating system),as long
as it does not exceed a temperature of 60°C. In this case, the wash
cycle time will be shortened by about 15 minutes and the wash ef-
ficiency slightly reduced.
The connection must be made to the hot water line following the
same procedures as those for the connection to the cold waterline.
Positioning the Appliance
Position the appliance in the desired location. The back should rest
against the wall behind it, and the sides, along the adjacent cabi-
nets or wall. The dishwasher is equipped with water sup ply and
drain hoses that can be positioned to the right or the left to facili-
tate proper installation.
Leveling the Appliance
Once the appliance is positioned, adjust
the feet (screwing them in or out) to ad-
just the height of the dishwasher, making
it level. In any case, the appliance should
not be inclined more than 2°.
WATER CONNECTION