Elenberg DW-9205 - Инструкция (Страница 34)

34
It is necessary to clean the spray arms regularly for hard water
chemicals will clog the spray arm jets and bearings. To remove the
spray arm, screw off the nut to take out the washer on top of the
spray arm and remove the arm. Wash the arms in soapy and warm
water and use a soft brush to clean the jets. Rep lace them after
rinsing them thoroughly.
Cleaning the Filters
For best performance and results, the filter
assembly must be cleaned.
The filter efficiently removes food particles
from the wash water, allowing it to be recir-
culated during the cycle. For this reason, it is
a good idea to remove the larger food parti-
cles trapped in the filter after each wash cycle
by rinsing the semicircular filter and cup under running water. To
remove the filter assembly, pull on the cup handle in the upward
direction. The entire filter assembly should be cleaned at least once
a month.
To clean the coarse filter and the fine filter, use a cleaning brush.
Then, reassemble the filter parts as shown in the figures left and re
insert the entire assembly in the dishwasher, positioning in its seat
and pressing downward.
The dishwasher must never be used without the filters. Improper
replacement of the filter may reduce the performance level of the
appliance and damage dishes and utensils
WARNING!
Never run the dishwasher without the filters in place.
Cleaning the Door
To clean the edge around the door, you should
use only a soft warm, damp rag. To prevent
penetration of water into the door lock and
electrical components, do not use a spray
cleaner of any kind.
Also, never use abrasive cleaners or scour-
ing pads on the outer surfaces because they will scratch the finish.
Some papers towels can also scratch or leave marks on the sur-
face.
WARNING!
Never use a spray cleaner to clean the door panel for it could dam-
age the door lock and electrical components. It is not allowed to
use the abrasive agent or so me paper towel because of the risk of
scratching or leaving spots on the stain less steel surface.