Elenberg DW-9205 - Инструкция (Страница 29)

29
dishwasher.
• Do not add detergent.
• Pour two cups of vinegar into a bowl and set the bowl face up on
the lower rack of the dishwasher.
• Run the dishes through a normal wash program.
If this doesn’t work, try the same process with 1 /4 cup of citric acid
crystals instead of vinegar.
Proper Use of Detergent
Use only detergent specifically made for use in dishwashers.
Keep your detergent fresh and dry. Don’t put powder detergent into
the dispenser until You’re ready to wash dishes.
WARNING!
Dishwasher detergent is corrosive! Take care to keep it out of reach
of children.
• To open the dispenser, turn the cap to the
“open” (left) arrow and lift it out.
• Pour the rinse aid into the dispenser, being
careful not to overfill.
• Replace the cap by inserting it aligned with
“open” arrow and turning it to the closed (right)
arrow.
The rinse aid is released during the final rinse to prevent water from
forming droplets on your dishes that can leave spots and streaks. It
also improves drying by allowing water to “sheet” off the dishes.
Your dishwashers are designed to use liquid rinse aids. The rinse
aid dispenser is located inside the door next to the detergent dis-
penser. To fill the dispenser, open the cap and pour the rinse aid
into the dispenser until the level indicator turns completely black.
The dispenser holds about 100 ml of liquid rinse aid.
Be careful not to overfill the dispenser, because this could cause
oversudsing. Wipe away any spills with a damp cloth.
Don’t forget to replace the cap before you close the dishwasher
door.
If you have soft water, you may not need rinse aid for it may cause
a white film to develop on your dishes.
Adjusting Rinse Aid Dispenser
A measured amount of rinse aid is released during the final rinse.
As with detergent, the amount of rinse aid needed for your dishes
depends on the hardness of the water in your area. Too much rinse
aid can result in lather of foaming and cause cloudiness or steaks
RINSE AID DISPENSER