Vitek VT-3633 - Инструкция (Страница 3)

INSTALLATION
PRECAUTIONS
•
Choose the mounting location carefully so that the unit will not interfere with the normal driving func
tions of the driver.
• Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight
or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration.
• Use only the supplied mounting hardware for a safe and secure installation.
• Be sure to remove the front panel before installing the unit.
NOTE: Inclination angle for car radio installation must not exceed 30° otherwise the front panel will not
open.
Note: Keep the release key in the safe place, as you may need it in future to remove the unit from the car.
TO SUPPORT THE UNIT
3
ENGLISH
14
1. UNIT
2. RELEASE CASE
3. HEX NUT
4. LOCK WASHER
5. PLAIN WASHER
6. CAR BODY
7. REAR SUPPORT STRAP
8. TAPPING SCREW
9. M5 X 15 HEX BOLT
ПОДСОЕДИНЕНИЕ 4 ДИНАМИКОВ
СТАНДАРТНЫЙ СОЕДИНИТЕЛЬНЫЙ ПРОВОД (ISO)
4 SPEAKER WIRING
ISO CONNECTOR
ПОДСОЕДИНЕНИЕ 2 ДИНАМИКОВ
СТАНДАРТНЫЙ СОЕДИНИТЕЛЬНЫЙ ПРОВОД (ISO)
2 SPEAKER WIRING
ISO CONNECTOR
СТОРОНА A
4: Желтый
5: Голубой
7: Красный
8: Черный СТОРОНА B
1: Фиолетовый
2: Фиолетовый/Черный
3: Серый
4: Серый/Черный
5: Белый
6: Белый/Черный
7: Зеленый
8: Зеленый/Черный
СТОРОНА A
4: Желтый
5: Голубой
7: Красный
8: Черный СТОРОНА B
3: Серый
4: Серый/ Черный
5: Белый
6: Белый/ Черный
SIDE A
4: Yellow
5: Blue
7: Red
8: Black SIDE B
3: Gray
4: Gray/Black
5: White
6: White/Black
SIDE A
4: Yellow
5: Blue
7: Red
8: Black SIDE B
1. Violet
2. Violet/Black
3. Gray
4. Gray/Black
5. White
6. White/Black
7. Green
8. Green/Black
LINE OUT GREY: RED (R)
WHITE (L)
3633.qxd 16.02.04 16:14 Page 4