KORTING OKB481CRC - Инструкция (Страница 26)

DESCRIPTIONS OF ACCESSORIES
front part
C
A = wire shelves B = Drip dray (optional) D = Grill pan set
NOTE: Install the grids, by placing them on the horizontal
slides inside the oven wall. The raised part of the grid must be
in face of the oven rear wall (fig. 4).
Cooling motor
Some models are equipped with tangential cooling motor.
TURNSPIT (optional)
The turnspit is an optional available only in
some models. Central turnspit see figure 5. Di­
agonal turnspit see figure 5A.
Use of the turnspit.
■ Thread the chicken or the cubes of meat for
roasting on below spit L, ensuring that
it is gripped safely between the two forks F
(fig. 5).
■ Put the spit on support G, .
I Put support G completely into the oven.
I Fit the end of the spit into the motor M at the
back of the oven
I Place the oven tray with a little water on the
lowest shelf of the oven.
I Close the oven door.
I Turn the knob to position grill (
ac­
cording to the models) to start up the motor.
I When removing the spit, wear oven mitts
and pull out support G.
26