Panasonic SC-AK410 - Инструкция (Страница 24)

Turning the demo function off Auto-off function
Remote control only
«jteoff
AUTO OFF------------O
-DISP/ -
-DEMO
-4]
A demonstration of the display is shown if you have not set the clock.
You can reduce the power consumed in standby mode by turning it off.
Hold down [-DISP/-DEMO] until “NO DEMO” is displayed.
Every time you hold down the button:
NO DEMO (off) ^ DEMO ON (on)
To show a demonstration of the display
Hold down [-DISP/-DEMO] until “DEMO ON” is displayed.
DEMO function cannot be turned on when Dimmer is on.
Convenient functions
DIMMER -
SHIFT--------O
When CD or tape is selected as the source
To save power, the unit turns off if it is left unused for ten minutes.
This function does not work if the source is tuner or AUX.
Press [SHIFT] + [AUTO OFF].
“AUTO OFF” is shown on the display.
The setting is maintained even if the unit is turned off.
If you select tuner or AUX as the source, “AUTO OFF” goes out. It
comes on again when you select CD or tape.
To cancel
Press [SHIFT] + [AUTO OFF] again.
Setting the time
Remote control only
1 ------ 2*4
-DISP/ -
-DEMO
-G — VOLUME
MUTING---------------5^
To dim the display panel
Remote control only
Press [DIMMER].
The display is dimmed and the indicators are turned off.
(The AC supply indicator remains on.)
Press [DIMMER] again to restore the display.
Switching displays
Press [-DISP/-DEMO] to select the desired spectrum
anaiyzer.
Every time you press the button:
Normal
t____
Peak hold -► Aurora
---------- (OFF) ---- --------
Reflection
To mute the volume
Remote control only
Press [MUTING].
Press the button again to cancel.
“MUTING” goes out.
To cancel from the unit, turn [VOLUME] to minimum (-dB), then raise
it to the required level.
Muting is also cancelled when the unit is turned off.
-- 3
2 . 4 - ^
This is a 24-hour clock.
1 Switch on the unit.
2 Press [SHIFT] + [CLOCK/TIMER] to select “CLOCK”.
Every time you press the button:
CLOCK — ©PLAY — ©REC
t— Previous display -«—I
3 (within 7 seconds or so)
Press [!◄◄, REW/V] or [I , A/FF] to set the time.
4 Press [SHiFT] + [CLOCK/TiMER] to finish setting the
time.
The display will return to whatever was displayed before you set
the time.
To display the time
Press [SHIFT] -r [CLOCK/TIMER] once when the unit is on or at
standby mode.
The time is shown for about 5 seconds.
una
Reset the clock regularly to maintain accuracy.
RQT6699