Panasonic ER-GC50 - Инструкция (Страница 7)


English
7
Bladelife
Blade life will vary according to the frequency and length of use. It
is expected to be about  years when using the clipper twice a
month for 0 minutes each time. If cutting efficiency is reduced
despite proper maintenance, change the blades.
Batterylife
Battery life will vary according to the frequency and length of use.
If the batteries are charged 3 times a month, the service life will be
approximately 3 years.
It is recommended that the clipper be recharged at least every 6
months even when not in regular use because the charge will
drain from the battery and its service life may be shortened.
Disposaloftheclipperbattery
Remove the built‑in rechargeable battery before disposing of the
clipper. Please make sure that the battery is disposed of at an
officially designated location if there is one. Do not dismantle or
replace the battery so that you can use the clipper again. This
could cause fire or an electric shock. Replace it at an authorized
service center.
Disconnect the power cord from the clipper when removing the
battery.
Discharge the battery completely before removing it.
Be careful not to short the + and – terminals of the battery after
removing it.
Perform steps 1 to 8 and lift the battery, and then remove it.
1. Disconnect the power cord from the clipper.
. Remove the blade from the clipper. Remove the  screws (a).
3. Remove the screw (b).
4. Detach the dial cover (c), remove the screw (d) and disconnect
the dial (e).
5. Detach the housing (f).
6. Remove the screws (g).
7. Disconnect housing (h).
8. Disconnect the battery chamber (i) and remove the battery (j).
►
►
•
•
•
•
•
WARNING
Donotattempttoreplacethebatteryforthepurposeof
reusingtheclipper.Thiscouldresultintheriskoffireor
electricshock.
Importantnoticeregardingenvironmentalprotection
The built‑in rechargeable Nickel‑Metal Hydride battery contains
substances that may be environmentally harmful. Please remove
the battery before discarding your clipper.
Forenvironmentalprotectionandrecyclingofmaterials
This clipper contains a Nickel‑Metal Hydride battery. Please
make sure that the battery is disposed of at an officially assigned
location, if there is one in your country.
Specifications
Power source
See the name plate on the AC adaptor.
(Automatic voltage conversion)
Motor voltage 1. V DC
Charging time Approx. 8 hours
This product is intended for household use only.