Panasonic ER-GC50 - Инструкция (Страница 4)

4
English
1.Cuthairbyplacingtheclipperhead
directlyonthescalp.
Installingtheattachmentcomb
Combattachment[A](1mmto5mm)
1.Alignthe
instruction
mark“ ”to
“1”.
2.Mountthe
comb
attachment[A]
tothemain
body.
3.Alignthe
instruction
mark“ ”to
thelengthyou
wanttocut.
Cutting length (mm)
(estimate)
1  3 4 5
Scale marks 1  3 4 5
The dial will turn past the indicator “6” even when the comb
attachment [A] is being used. The clipper will not cut well above
6 mm, so do not try to cut more than 6 mm with the comb
attachment [A] mounted.
Actual hair length will be a little longer than the height you set. •
•
ACoperation
You can use the clipper while charging, even if the battery
capacity is low.
If the clipper does not work, continue charging it for approx. 1
minute.
Using
Usingcombattachments
1.Slidethepowerswitchonthemainbodyto
the“0”positiontoturnofftheclipper.
2.Makesurethereisnodamagetotheblade.
3.Mounttheattachmentandadjustthedial.
See pages 4 and 5. •
4.Slidethepowerswitchonthe
mainbodytothe“1”positionto
turnontheclipper.
After adjusting the trimming length,
make sure the attachment is fixed with
the switch in the “1” position. When
the attachment is mounted correctly,
the dial will not turn with the switch set
to “1”.
5.Cuthairtothecorrectheightby
movingtheclipperbackagainstthe
flowofthehair.
Do not use the clipper in an inverted position.
This can cut hair too deeply.
Trimmingwithoutattachmentcombs
Trimming your hair without an attachment will trim hair length to
approx. 0.5 mm.
►