Nilfisk-ALTO EXCELLENT 125/135 X-TRA - Инструкция (Страница 7)

7
Accessories
EN
Maintenance
EN
The inlet fi lter must always be fi tted inside the water
inlet pipe to fi lter out sand, limestone and other
impurities, as they will damage the pump valves.
CAUTION: Failure to fi t the fi lter will invalidate the
guarantee.
4.3 Cleaning of machine vents
The machine should be kept clean so as to let cool-
ing air pass freely through the machine vents.
Metal Cleaner For cleaning of metal such as
garden tools.
Car Combi Cleaner For cars etc. With rinsing wax.
Alu Cleaner For surfaces of aluminium.
Applied with an atomizer.
Oil & Grease For cleaning of grease and
Cleaner oil on motors for instance.
Applied with an atomizer.
Wood Cleaner For cleaning of wooden sur-
faces incl. of wooden garden
furniture.
4.0 Maintenance EN
WARNING! Always disconnect the electrical plug
from the socket prior to maintenance or cleaning.
To ensure a long and problem free working life,
please take the following advice:
Wash out water hose, high pressure hose, spray
lance and accessories before mounting.
Clean the connectors of dust and sand.
Rinse the detergent spraying attachment after
use.
Any repair should always be made in an authorized
workshop with original spare parts.
4.1 Cleaning of nozzle
A clogging up in the nozzle causes a pump pres-
sure which is too high. This is why cleaning is re-
quired immediately.
1. Stop the machine and disconnect the nozzle.
2. Clean the nozzle. IMPORTANT: The cleaning
tool (4) should only be used when the nozzle is
detached!
3. Flush the nozzle backwards with water.
4.2 Cleaning of water inlet fi lter
Clean the water inlet fi lter regularly once a month or
more frequently according to use. Carefully loosen
the fi lter with a screwdriver and clean it. Check that
it is intact before re-mounting it.
5.0 Storage EN
The machine should be stored in a frost-free
room!
Pump, hose and accessories should always be
emptied of water prior to storing as follows:
1. Stop the machine (press the On/Off switch “O” (1)
and detach water hose and accessory.
2. Restart the machine and activate the trigger (9b).
Let the machine run until no more water runs
through the spray gun (9).
3. Stop the machine, unplug and wind up hose and
cable (5).
4. Place spray handle, nozzles and other accesso-
ries in the holders of the machine.
Should the machine by mistake be frozen, it will be
necessary to check it for damage.
NEVER START-UP A FROZEN MACHINE.
Frost damages are not covered by the
guarantee!
6.0
Environmental protection
Recycle unwanted materials instead of
disposing of them as waste. All tools,
hoses and packaging should be sorted,
taken to the local recycling center and
disposed of in an environmentally safe way.