Beko CDA 38200 - Инструкция (Страница 15)

GB
Instruction for use
Trouble-shooting guide
In case your appliance does not work
please check if:
•
There is an electricity breakdown.
•
The plug of the supply cord is not introduced
properly into the socket.
•
The fuse is blown.
The temperatures are not low enough.
•
The doors were not closed properly.
•
The food prevents the doors from closing.
•
The appliance was not located correctly.
•
The appliance is too close from a heat
source.
The inside lighting does not work while the
compressor is running.
•
The lamp is blown. Unplug the appliance
from the mains, take out the lamp and replace
it with a new one.
There is water in the lower side of the
refrigerator compartment.
•
The water drain groove is clogged.
There is water in the lower side of the
refrigerator compartment.
•
The water drain groove is clogged.
Too much ice build-up on the rear side of
the refrigerator compartment.
•
Remove the possible cause of the „ice build-
up” forming (the packets which come into
contact with the cold wall.
•
Do a manual defrosting (similar with the one
described for the freezer compartment) until
the complete thawing of the ice.
•
After the functionning resuming, please
follow if the automatic defrosting is done
completely.
Too much ice build-up in the freezer
compartment
•
The door is not closed properly.
•
The door cannot close due to food.
The follow ing are not defects
If the red led lights for a short time. This can
be caused by the introduction of food into the
freezer compartment or by the warm air in
case the door was left open for a longer time.
The led will go off immediately as the
temperature in the freezer will have a suitable
temperature
The fact that on the rear side of the freezer
compartment is warm. This is done on
purpose, to warn the building of the condense
on the outside of the appliance (due to the
moisture in the kitchen).
9