Instructions for use – Инструкция по эксплуатации Binatone FD-2685
Страница 6
6
INSTRUCTIONS FOR USE
1. Wash well the produce, cut out soft and spoilt
parts. Dry well with a cloth or kitchen paper.
Cut into pieces of roughly the same size and
thickness. Produce that requires a long cook-
ing time should be blanched briefly before
dehydrating (see the subsection «Useful
tips»).
2. Spread the produce evenly over the trays (4). Do not allow
pieces to overlap.
Note:
See that only about 90% of the tray surface is
covered to ensure good air circulation. For best
results, remove the trays which are not needed.
3. Stand the trays vertically. Close the lid (1).
Note:
Depending on the size of the produce, the trays can be
vertically adjusted by rotating the tray half a turn.
4. Connect the appliance into a socket with a power supply.
5 . Power ON/OFF the appliance
Press and hold the power button (8) for 1 second to switch the
appliance ON/OFF, at the same time, the LCD display (6) will turn
on/off. Hours:Minutes is shown "- -:- -" if the timer is not activated
(manual mode).
6 . Drying mode control
Quick press the «"»/«#» (9) to select the Low/High drying
mode.
The 2-setting control switch (see Figure B) is used to set the right
temperature for the produce to be dehydrated. Select setting Low
for produce with a low water content such as herbs, mushrooms,
spinach, onions etc., and setting High, for produce with a moderate
water content e.g. apples, apricots, peaches, plums, etc.
Note:
Do not afraid to experiment a bit. You will soon have
a clear idea of which setting is best for your particular
produce.
7 . Setting the Timer program
Press and hold the timer button (7) for 2 seconds to enter the
TIMER setting mode, set the Hours setting by a quick press
«"»/«#» toggler (9). Quick press the timer button (7) , set the
Minutes setting by a quick press «"»/«#» toggler (9).
Note:
You can quick press the timer button (7) to reset the
Hours
setting again.
The appliance will start automatically upon the last selection by
no further key activity for 5 seconds. Hours:Minutes is shown
the time remaining for auto-off count down when the timer pro-
gram is running.
8. Pause the Timer program
Pause mode is for timer only. It is not function for manual mode.
Press any key to activate the electronic control.
Press Timer button (7) to pause the timer while the program is
running.