Step 4 two dog system, Sv fi da no ru en, Care and cleaning – Инструкция по эксплуатации Petsafe PDT20-11946
Страница 145: Remote transmitter, Receiver collar
144
www.petsafe.net
www.petsafe.net
145
SV
FI
DA
NO
RU
EN
Care and Cleaning
To ensure the effectiveness of this product and the comfort and safety of your dog, check
the fit of his collar frequently. This Operating Guide describes proper collar fitting. If you
notice that your dog is experiencing skin irritation, discontinue use of the collar for a few
days. If the condition persists beyond 48 hours, see your veterinarian.
STEP 4
Two Dog System
Note: If you wish to add another receiver collar to the training system, extra Receiver
Collars are available where you bought your training system or through our Customer
Care Centre. For a listing of Customer Care Centre telephone numbers, visit our website at
www.petsafe.net.
To Add Dog 2
(PDT20-11977 350 m Add-A-Dog
®
; PDT20-11979 900 m Add-A-Dog
®
)
Remote Transmitter
1. Press the Lower Right button until “2D” appears on the Digital Display.
2. After the “2D” appears press the +2 Boost button.
3. Set Dog 2 to Stimulation Level 1.
4. Press +2 Boost button to lock the stimulation level for Dog 2.
Receiver Collar
1. With the Receiver Collar off your pet, turn the
Receiver Collar off.
2. Press and hold the On/Off button for
5 seconds.
3. The Receiver Collar will beep and the LED
will flash.
4. Press Dog 2 the Upper Right or Lower
Right button.
5. The Receiver Collar will respond and pair.
6. If the Receiver Collar does not beep twice,
please contact the Customer Care Centre. For
a listing of Customer Care Centre telephone
numbers, visit our website at
www.petsafe.net.
Digital Display
Dog 1 Tone
Dog 2
Tone
Charging Jack
(with cover)
Transmitter Antenna
Dog 1
Stimulation
Dog 2
Stimulation
+2 Boost
(see table below)
Button Functions
for Dog 2 Mode