Step 3 fit the receiver collar, Sv fi da no ru en – Инструкция по эксплуатации Petsafe PDT20-11946
Страница 144
144
www.petsafe.net
www.petsafe.net
145
SV
FI
DA
NO
RU
EN
STEP 3
Fit the Receiver Collar
Important: The proper fit and placement of your Receiver Collar is important for
effective operation. The Contact Points must have direct contact with your dog’s skin on the
underside of his neck.
Please see page 133 for Important Safety Information.
To assure a proper fit, please follow these steps:
1. Make sure that the Receiver Collar is turned off.
2. Start with your dog standing comfortably (
3A).
3. Place the Receiver Collar on your dog’s
neck close to the ears. Centre the Contact
Points underneath your dog’s neck,
touching the skin (
3B).
Note: It is sometimes necessary to trim the
hair around the Contact Points to make
sure that contact is consistent. Longer
probes are also available through our
Customer Care Centre.
Do not shave the
pet’s neck as this may
increase the risk of skin
irritation.
4. Check the tightness of the Receiver Collar
by inserting one finger between the collar
and your dog’s neck. The fit should be
snug but not constricting.
You should not make the collar any more tight than is required for
good contact. A collar that is too tight will increase the risk of pressure
necrosis in the contact area.
5. Allow your dog to wear the Receiver Collar for several minutes then recheck the fit.
Check the fit again as your dog becomes more comfortable with the Receiver Collar.
Note: If your dog is young and you expect him/her to grow, you’ll want to leave
excess strap to adjust the collar fastening. Replacement straps are available through
our Customer Care Centre.
3A
3B