Sv fi da no ru en – Инструкция по эксплуатации Petsafe PDT20-11946
Страница 142
142
www.petsafe.net
www.petsafe.net
143
SV
FI
DA
NO
RU
EN
To Turn the Receiver Collar On
1. Press and hold the On/Off button until the Green LED comes on and the Receiver
Collar beeps low to high.
2. Release the On/Off button. The Green LED will flash once every 5 seconds until the
Receiver Collar is turned off. The flashing light indicates the Receiver Collar is ready to
receive a radio signal from the Remote Transmitter.
3. Once the Receiver Collar has been turned on, press the Upper Left button of the
Remote Transmitter. Upon pressing, the Receiver Collar should beep for as long as the
Upper Left button is pressed. If it does not, see “To Pair the Remote Transmitter and the
Receiver Collar”. Note: To extend the life of the battery, turn the Receiver Collar off
when it is not in use.
350 metre Little Dog
Receiver Collar
900 metre Big Dog
Receiver Collar
On/Off Button
On/Off
Button
To Turn the Receiver Collar Off
1. Press and hold the On/Off button until the Red LED comes on and the Receiver Collar
beeps high to low.
2. Release the On/Off button. To extend the life between charging cycles, turn the
Receiver Collar off when it is not in use. Approximate battery life between charges is
40-50 hours, depending on frequency of use.