Petsafe PDT20-11946 - Инструкция (Страница 139)

138 www.petsafe.net www.petsafe.net 139
SV
FI
DA
NO
RU
EN
Turning ON the Transmitter
Power up the Transmitter by pressing any button. You will see the display turn on when you
press any button.
Transmitter Digital Display
The display stays on for 10 minutes after a button press. After 10 minutes with no button
presses, the display shuts off and the transmitter goes into battery conservation mode.
Pressing any button will cause the display to turn back on. The various symbols you might
see on the display are explained below.
Numeric
readout
Shows the chosen stimulation level for Dog
1 or Dog 2.
Dog 1/
Dog 2
The symbol displayed is the active dog
receiver collar. See “Two Dog System” on
page 145.
Tone or
Stimulation
When pressing Tone or Stimulation the Dog
1 or Dog 2 symbol will appear in bold or
emphasized.
Battery
Indicator
The battery indicator provides constant
awareness of your battery’s power level. See
the next section for more detailed information
on the Battery Indicator.
Note: Factory default setting is for Dog 1 mode, you will not see the Dog 2 symbol unless
the unit is programmed for Dog 2 (see “Two Dog System” on page 145).