ZELMER 28Z013 - Инструкция (Страница 62)

62 GW28-009_v01
Burst of steam in vertical position – Always follow the garment
manufacturer’s ironing instructions mentioned at the garment label.
This function provides extra amount of steam to remove wrinkles on
delicate garments in hanging position, hanging curtains, or other hanging
fabrics.
Warning:
Do not apply steam on any clothes or fabrics that are being worn by
human or pets. Temperature of steam is very high.
Fill the iron as described in “How to fill water”. –
Connect the iron to a suitable mains supply outlet (see „Preparation –
for operation“).
Turn the – Temperature Dial (9) in clockwise direction to ●●● position.
Control light (6) – glows, indicating that the iron is on.
Control light goes off when the required temperature is reached. The –
iron is now ready for use.
Remove the iron from the stand as described in “How to Use Iron –
Lock”.
Hold the iron between 15 and 30 centimetres away from the garment. –
Press the – Burst of Steam Button (4) once – steam will shoot from the
holes of the soleplate.
For stubborn wrinkles, wait a few seconds –
before pressing the Burst of Steam Button
(4) again. Most wrinkles can be removed
within three presses.
After finishing move the – Temperature Dial (9)
in anti-clockwise direction to „ MIN”; the iron is
switched off.
Lock the iron with stand as described in “How –
to Use Iron Lock”.
Move the – Steam Control Knob (3) to
position.
Disconnect the iron from mains supply outlet. –
When the iron gets cool completely, store it –
vertically in a safe place.
It may be necessary to press the burst of steam button a few times
to start this function.
For optimum steam quality, do not operate the Burst Of Steam more
than three times after the pilot light goes off.
Hold the iron some centimetres away from delicate garments (arti-
ficial, silk, velvet etc.), otherwise they can be damaged.
Build-in Anti-scale system
The build-in anti-scale cartridge is designed to reduce the build-up of lime
scale which occurs during steam ironing. This will prolong the work-ing
life of your iron. However, please note that the anti-scale cartridge will not
completely stop the natural process of lime scale build-up.
Self-cleaning
This function removes the scales and minerals built up in the Steam
Chamber.
The iron will remain in the best condition if this function is performed at
least once a month or more regularly depending on the hardness of the
water used.
Fill the iron as described in “How to fill water”. –
Lock the iron with stand as described in “How to Use Iron Lock”. –
Connect the iron to a suitable mains supply outlet. See „Preparation –
for operation”.
Turn the – Temperature Dial (9) in clockwise direction to „MAX“
position.
Control light (6) – glows, indicating that the iron is on.
Control light goes off when the required temperature is reached. The –
iron is now ready for use.
Wait for one more cycle; pilot light glows and goes off. –
After finishing move the – Temperature Dial (9) in anti-clockwise
direction to „ MIN”; the iron is switched off.
Disconnect the iron from mains supply outlet. –
Hold the iron horizontally over a sink. –
Press and hold the – Self-Cleaning Knob (7).
Steam and boiling hot water will drain from the holes on the soleplate –
washing away the scales and minerals that have built up inside the
Steam Chamber.