ZELMER 28Z013 - Инструкция (Страница 61)

61 GW28-009_v01
Control light (6) – glows, indicating that the iron is on.
Control light goes off when the required temperature is reached. The –
iron is now ready for use.
Remove the iron from the stand as described in “How to Use Iron –
Lock”.
After operation lock the iron with stand as described in “How to Use –
Iron Lock”.
Move the – Temperature Dial (9) in anti-clockwise direction to „MIN”;
the iron is switched off.
Disconnect the iron from mains supply outlet. –
When the iron gets cool completely, store it vertically in a safe place. –
Steam ironing – Always follow the garment manufacturer’s
ironing instructions mentioned at the garment label.
Unwind and straighten the – power cord (11).
Lock the iron with stand as described in “How to Use Iron Lock”. –
Fill the iron as described in “How to fill water”. –
Connect the iron to a suitable mains supply outlet. –
Turn the – Temperature Dial (9) in clockwise direction to ●●● position.
(For optimum steam quality, do not use ● or ●● setting for steam
ironing).
Control light (6) – glows, indicating that the iron is on.
Control light goes off when the required temperature is reached. The –
iron is now ready for use.
Remove the iron from the stand as described in “How to Use Iron –
Lock”.
Move the – Steam Control Knob (3) to selected position, in order to set
the amount of steam.
After finishing move the – Temperature Dial (9) in anti-clockwise
direction to „ MIN”; the iron is switched off.
Move the – Steam Control Knob (3) to position.
After operation lock the iron with stand as described in “How to Use –
Iron Lock”.
Disconnect the iron from mains supply outlet. –
When the iron gets cool completely, store it vertically in a safe place. –
Burst of steam – Always follow the garment manufacturer’s
ironing instructions mentioned at the garment label.
This function provides extra amount of steam to remove stubborn –
wrinkles at clothes and hanging garments.
Unwind and straighten the – power cord (11).
Fill the iron as described in “How to fill water”. –
Lock the iron with stand as described in “How to Use Iron Lock”. –
Connect the iron to a suitable mains supply outlet. –
Turn the – Temperature Dial (9) in clockwise direction to ●●● position.
See preparation for operation.
Control light (6) – glows, indicating that the iron is on.
Control light goes off when the required temperature is reached. The –
iron is now ready for use.
Remove the iron from the stand as described in “How to Use Iron –
Lock”.
Press the – Burst of Steam Button (4) once – steam will shoot from the
holes of the soleplate.
For stubborn wrinkles, wait a few seconds before pressing the Burst of –
Steam Button (4) again. Most wrinkles can be removed within three
presses.
After finishing move the – Temperature Dial (9) in anti-clockwise
direction to „ MIN”; the iron is switched off.
Move the – Steam Control Knob (3) to position.
After operation lock the iron with stand as described in “How to Use –
Iron Lock”.
Disconnect the iron from mains supply outlet. –
When the iron gets cool completely, store it vertically in a safe place. –
ATTENTION:
It may be necessary to press the burst of steam button a few times
to start this function.
For optimum steam quality, do not operate the Burst Of Steam more
than three times after the pilot light goes off.