ZELMER 28Z030 - Инструкция (Страница 54)

54 GW28-025_v01
Self-cleaning
This function removes the scales and minerals built up in the Steam
Chamber.
The iron will remain in the best condition if this function is performed at
least once a month or more regularly depending on the hardness of the
water used.
Fill the iron as described in “How to fill water”. –
Connect the iron to a suitable mains supply outlet. See „Preparation –
for operation”.
Turn the – Temperature Dial (2) in clockwise direction to „MAX“ position.
Control light (10) – glows, indicating that the iron is on.
Control light goes off when the required temperature is reached. The –
iron is now ready for use.
Wait for one more cycle; pilot light glows and goes off. –
After finishing move the – Temperature Dial (2) in anti-clockwise direc-
tion to „ MIN”; the iron is switched off.
Disconnect the iron from mains supply outlet. –
Hold the iron horizontally over a sink. –
Press and hold the – Self-Cleaning Knob (7).
Steam and boiling hot water will drain from the holes on the soleplate –
washing away the scales and minerals that have built up inside the
Steam Chamber.
Gently move the iron back and forth until the water tank is empty. –
When Self-Cleaning is complete, release the Self-Cleaning Knob. –
Rest your iron at the stand and allow to fully cool down. –
Wipe the soleplate with a cold damp cloth. –
Caution!
Keep skin/body away from the hot water.
Anti-Drip System
The system, which is designed to pre- –
vent automatically water escaping from
the sole-plate when the iron is too cold.
During use, the anti-drip system may –
emit a loud clicking sound, particularly
during heat-up or whilst cooling down.
This is per-fectly normal and indicates
that the system is functioning correctly.
Draining the water
Move the – Steam Control Knob (6) to
position.
Disconnect the iron from mains supply out- –
let.
Press the – Burst of Steam Button (9), to re-
lease any trapped water when the soleplate
still hot.
Press the – Spray Buttons (8), to release
any trapped water.
Turn the iron upside down and gently shake –
it to remove the remaining water.
Before storage make sure that Steam Con-
trol Knob (6) is in position.
Cleaning and maintenance
Disconnect the iron from mains supply outlet. –
The iron should get cool completely before cleaning. –
Use a damp cloth and gentle washing liquid for cleaning. –
Do not use aggressive detergents like cream, milk, paste etc. to clean –
the casing. They can remove graphic symbols such as: scales, mark-
ing, caution signs, etc.
Never use sharp or rough objects to remove the deposits on the sole –
plate.
Never use any abrasive, vinegar or descaling agents to clean the iron. –