Инструкция по эксплуатации ZELMER 28Z030

Страница 53

Advertising

GW28-025_v01

Burst of steam

– Always follow the garment manufacturer’s

ironing instructions mentioned at the garment label.
This function provides extra amount of steam which can be used for iron-

ing very wrinkled (crumpled) clothes.

Unwind and straighten the

–

power cord (12).

Fill the water tank in as described under “How To Fill Water”.

–

Connect the iron to a suitable mains supply outlet.

–

Turn the

–

Temperature Dial (2) in clockwise

direction to ●●● position. See preparation for

operation.

Control light (10)

–

glows, indicating that the

iron is on.

Control light goes off when the required tem-

–

perature is reached. The iron is now ready for

use.

Press the

–

Burst of Steam Button (9) once –

steam will shoot from the holes of the soleplate.

For stubborn wrinkles, wait a few seconds before pressing the Burst of

–

Steam Button (9) again. Most wrinkles can be removed within three

presses.

After finishing move the

–

Temperature Dial (2) in anti-clockwise direc-

tion to „

MIN”; the iron is switched off.

Move the

–

Steam Control Knob (6) to position.

Disconnect the iron from mains supply outlet.

–

When the iron gets cool completely, store it vertically in a safe place.

–
ATTENTION:

It may be necessary to press the burst of steam button a few times

to start this function.

For optimum steam quality, do not operate the Burst Of Steam more

than three times after the pilot light goes off.

Burst of steam in vertical position

– Always follow the garment

manufacturer’s ironing instructions mentioned at the garment label.
This function provides extra amount of steam to remove wrin-

kles on delicate garments in hanging position, hanging curtains,

or other hanging fabrics.

Warning:

Do not apply steam on any clothes or fabrics that are being worn by

human or pets. Temperature of steam is very high. Never direct the

steam to human or pets.

Fill the water tank in as described under “How To Fill Water”.

–

Connect the iron to a suitable mains supply outlet.

–

Turn the

–

Temperature Dial (2) to ●●● position. See „Preparation for

operation“.

Control light (10)

–

glows, indicating that

the iron is on.

Control light goes off when the required

–

temperature is reached. The iron is now

ready for use.

Hold the iron between 15 and 30 centime-

–

tres away from the garment.

Press the

–

Burst of Steam Button (9)

once – steam will shoot from the holes of

the soleplate.

For stubborn wrinkles, wait a few seconds before pressing the

–

Burst

of Steam Button (9) again. Most wrinkles can be removed within

three presses.

After operation turn the

–

temperature dial knob (2) in counter clock-

wise direction to „

MIN” position. The iron is switched off.

Lock the iron with stand as described in “How to Use Iron Lock”.

–