Zanussi ZGL646IT - Инструкция (Страница 20)

Warning! Do not use abrasive cleaners, steel wool
pads or acids, they can cause damage to the
appliance.
• You can remove the pan supports to easily clean the
hob.
• To clean the enamelled parts, cap and crown, wash it
with warm soapy water.
• Stainless steel parts wash with water, and then dry with
a soft cloth.
• The pan supports are not dishwasher proof; they must
be washed by hand .
• When you wash the pan supports by hand, take care
when you dry them as the enamelling process occa-
sionally leaves rough edges. If necessary, remove
stubborn stains using a paste cleaner.
• Make sure you position the pan supports correctly after
cleaning.
• To make burners work correctly, make sure that the
arms of the pan supports are in the centre of the burner.
• Be very careful when you replace the pan supports to
prevent the hob top from damage.
After cleaning, dry the appliance with a soft cloth.
Removing the dirt:
1. – Remove immediately: melting plastic, plastic foil,
and food containing sugar.
– Stop the appliance and let it cool down before you
clean: limescale rings, water rings, fat stains, shi-
ny metallic discolorations. Use a special cleaner
applicable for surface of hob.
2. Clean the appliance with a damp cloth and some de-
tergent.
3. At the end rub the appliance dry with a clean cloth.
Cleaning of the spark plug
This feature is obtained through a ceramic ignition candle
and a metal electrode. Keep these components well clean
to prevent difficult lighting and check that the burner
crown holes are not obstructed.
Periodic maintenance
Periodically speak your local Service Force Centre to
check the conditions of the gas supply pipe and the pres-
sure adjuster, if fitted.
What to do if…
Problem Possible cause Remedy
There is no spark when lighting the
gas
• There is no electrical supply • Make sure that the unit is connec-
ted and the electrical supply is
switched on.
• Examine the house electrical in-
stallation fuse.
• Burner cap and crown are placed
uneven
• Make sure that the burner cap and
crown are in correct positions.
The flame is blow out immediately
after ignition
• Thermocouple is not heated suf-
ficient
• After lightning the flame, keep the
knob pushed for approximately 5
seconds.
The gas ring burns unevenly • Burner crown is blocked with food
residues
• Make sure that the injector is not
blocked and the burner crown is
clear of food particles.
If there is a fault, first try to find a solution to the problem
yourself. If you cannot find a solution to the problem
yourself, speak your dealer or the local Service Force
Centre.
If you operated the appliance incorrectly, or the in-
stallation was not carried out by a registered engi-
neer, the visit from the customer service technician or
dealer may not take place free of charge, even during the
warranty period.
20