Zanussi ZGL646IT - Инструкция (Страница 19)

2. Keep the control knob pushed for approximately 5
seconds; this will let thermocouple to warm up. If not,
the gas supply will be interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner does not light, check
if the crown and its cap are in correct positions.
3
4
2
1
1 Burner cap
2 Burner crown
3 Ignition candle
4 Thermocouple
Warning! Do not keep the control knob pushed for
more than 15 seconds.
If the burner does not light after 15 seconds, release the
control knob, turn it into off position and try to light the
burner again after minimum 1 minute.
Important! In the absence of electricity You can ignite the
burner without electrical device; in this case approach the
burner with a flame, push the relevant knob down and turn
it counter-clockwise to maximum gas release position.
If the burner accidentally goes out, turn the control
knob to the off position and try to light the burner
again after minimum 1 minute.
The spark generator can start automatically when
you switch on the mains, after installation or a power
cut. It is normal.
Turning the burner off
To put the flame out, turn the knob to the symbol .
Warning! Always turn the flame down or switch it
off before you remove the pans of the burner.
Helpful hints and tips
Energy savings
• If possible, always put the lids on the pans.
• When the liquid starts to boil, turn down the flame to
barely simmer the liquid.
Warning! Use pots and pans with bottom applicable
to the dimension of burner.
Do not use cooking vessels on the hotplate that overlap
its edges.
Burner Diameters of cookware
Rapid 160 mm - 260 mm
Burner Diameters of cookware
Semi-rapid 120 mm - 220 mm
Auxiliary 80 mm - 160 mm
Warning! Pots must not enter the control zone.
Make sure pots do not protrude over the edges of the
cooktop and that they are centrally positioned on the rings
in order to obtain lower gas consumption.
Do not place unstable or deformed pots on the rings.
Care and cleaning
Warning! Switch the appliance off and let it cool
down before you clean it. Disconnect the appliance
from the electrical supply, before carrying out any
cleaning or maintenance work.
Warning! For safety reasons, do not clean the
appliance with steam cleaners or high-pressure
cleaners.
19