Kenwood DF560 - Инструкция (Страница 5)

know your Kenwood deep fryer
safety
● Read all instructions.
● Never plug in the fryer before filling the bowl with oil.
● Keep children away during use and after - fat stays hot
for a long time.
● Never let the cord touch hot surfaces or hang down
over the worktop edge - a child could grab it and pull
the fryer down. Place excess cord in cord storage area
at the back of the fryer.
● Never touch the bowl, pour away oil or move your fryer
while the oil’s hot.
● Never touch hot surfaces especially the lid and metal
trim.
● Never put the electronic control in water. Remove it
before washing the rest of your fryer.
● After cleaning, ensure the bowl and its electric pins are
dry before use.
● Never leave your fryer on unattended.
● This fryer is not intended for use by young children or
infirm persons without supervision.
● Young children should be supervised to ensure that
they do not play with this appliance.
● Take care when removing the electronic control - the
temperature probes may be hot.
● Do not use if there is any damage to the fryer, cord or
plug. Get it checked or repaired: see ‘service’.
● Only use the electronic control supplied with the DF560
model.
● Watch out for steam during cooking and when you
open the lid.
● Never put your fryer near or on cooker hot plates.
● This fryer is for domestic use only.
● Always unplug the fryer after use.
before plugging in
● Make sure your electricity supply is the same as the
one shown on the underside of the electronic control.
● This machine complies with European Economic
Community Directive 89/336/EEC.
before using for the first time
1 Remove all packaging.
2 Dismantle: see ‘to dismantle, assemble and use your
fryer’.
3 Wash the parts: see ‘cleaning’.
know your Kenwood fryer
ቢ removable lid with permanent mesh filter
ባ viewing window
ቤ lid seal
ብ condensation trap
ቦ rise and fall control
ቧ pouring lips
ቨ removable bowl
ቩ lid release
ቪ carrying handles
ቫ electronic temperature control unit
ቭ on/off button
ቮ temperature buttons - 150, 170, 190°C
ቯ oil change light
ተ timer
ቱ temperature probes
ቲ cord storage
to dismantle, assemble and use
your fryer
to dismantle
1 Push the lid release
ቩ down to open the lid. Then lift
the lid off.
2 Lift up the handle and remove the basket.
3 Pull out the electronic control unit and then remove the
bowl.
● Before removing the electronic control unit
check that the cord is released from the cord
storage area at the back of the fryer .
to assemble and use
1 Insert the bowl – ‘MAX’ and ‘MIN’ marks to the back of
the fryer.
2 Then insert the electronic control unit
ቫ – cord to the
back of the fryer + .
3 Pour in the oil. The level must be between the ‘MAX’
and ‘MIN’ marks .
4 Insert the basket and close the lid. Then lower the
handle by sliding back the rise & fall control
ቦ.
5 Plug in and switch on
ቭ. Press the button for the
required temperature
ቮ and the light will come on.
Note: When the oil reaches the right
temperature for frying a single beep will
sound and the light will flash slowly.
2