Auxiliary outputs, Cyborg, Таблица команд пульта управления. (продолжение) – Инструкция по эксплуатации Mongoose Cyborg
Страница 10
Two Way Car Alarm System MONGOOSE CYBORG
23
ENGLISH
Pager Test
Once button 4 is pressed with the alarm system armed or armed with the engine running a
Pager Test feature for current armed period will be included, 5 minutes after you press button 4,
the system will transmit a test signal to the Hand Held Transceiver to test the range
of the pager system. The pager test indication will last for 2 minutes. You can
cancel the Pager Test indication before 2 minute period is over by pressing any
button of the Handset. This Pager Test will be available as many times as you press
button 4 within the armed period (one activation for each pressing).
When the transceiver receives a test signal the Pager Test icon will be displayed on the
LCD panel, the pager test melody will be sounding, and all symbols will be displayed on
the LCD panel one after another.
Auxiliary Outputs
Trunk Release Output
Pressing button 1 for 3 seconds activates the Trunk Release output. This will issue an impulse
on the trunk release output wire and will override the sensors and trunk input until 10 seconds
after the trunk switch is closed.
Comfort/Two Stage Unlock Output
If you set the programming for the Comfort Window Close option, the Output will be
automatically activated when the alarm system is armed either by remote control or by key or by
passive arming (not re arming) it remains active for 20 seconds. During the 20 second close
period and for the first 10 seconds after the comfort close period, the two sensor sockets will be
disabled. This is to ensure that the sensors cannot trigger the alarm system during the comfort
close period and to allow a 10 second settling period after the close period for the sensors to
settle.
If set the Two Stage Unlock will operate as describe in sections “Disarming” and “Ignition
Safety Door Lock/Unlock”.
Latch Output/Turbo Timer Output
The output will operate according to its setting to allow either the ignition supported arming
with engine running or the turbo timer mode.
If you turn on the Latch Output with pressing button 1 immediately after button 5 pressed
twice, the input will remain active until either disarming or pressing button 1 immediately after
button 5 pressed twice once again.
If you turn on the Turbo Timer Output with pressing either button 2 or button 3 immediately
after button 5 pressed twice, the input will remain active during 3 or 5 minutes respectively or
until alarm is triggered.
Руководство пользователя
CYBORG
38
Светодиодная индикация состояний системы.
Охрана включена
равномерные короткие вспышки
Включен пассивный иммобилайзер
равномерные длинные вспышки
Включен Anti Hi jack
равномерные короткие вспышки
Предупредительный режим Anti Hi jack
быстро мигает
Охрана отключена
не горит
Автопостановка/перепостановка
быстро мигает
Valet режим
горит постоянно
Заблокирован ввод PIN кода
двойные вспышки
кратковременно нажать один раз
3 сек.
нажать и удерживать кнопку в нажатом состоянии не менее 3 секунд
1 2
последовательность нажатия кнопок
Функция
Кнопка Кнопка
Кнопка Кнопка Кнопка
Примечание
1
2
3
4
5
Включение тестового режима пейджера
Охрана включена
Дополнительные функции двунаправленного пульта управления
Режим энергосбережения (временное выключение
2
1
пульта управления)
Блокировка кнопок пульта
2
1
Отключение/включение звукового сигнала
2
1
Отключение/включение виброзвонка
2
1
Включение подсветки дисплея, проверка таймера
парковки
Проверка состояния системы
Вход в режим установки часов
3сек
Вход в режим программирования пользовательских
3
( 3сек)1
функций
2
Отключение пассивного иммобилайзера
Номера кнопок задаются
Зажигание ВКЛ.
программированием
Таблица команд пульта управления. (продолжение)