Kastor SAGA Wood-burning sauna stoves - Инструкция (Страница 29)

29 / 51
•
Remove the frame from the screws on the side by lifting upwards and pull after that forward away
from the screws.
•
Push the extended door frame over the lead-through neck and also the ash compartment pipe, its
front edge goes into the slot in the front wall. Fasten in front with screws
.
•
Insulate the gap between the door extension and the wall with fireproof mineral wool.
Follow the instructions of the mineral wool manufacturer! Do not cover the air openings in
the upper edge of the frame with wool. They are situated right behind the upper edge of
the front frame.
•
Install the covering frame in place to its screws.
•
Tighten the screws so that the lower edge of the covering frame is near the floor.
•
Push the door frame so that the covering frame goes well in its place against the wall and fasten
the door inside the
tunnel with two screws.
2.5.3. Connecting from the back Saga
JK and KSIL stoves cannot be connected from the back of the chimney; they only have a flue
opening.
Make an opening into the brick chimney that is 2–3 cm larger than the connection pipe. Remove
the plate covering the hole in the back mantle with a screwdriver. Put the cap covering the back
flue opening as the cap of the backmost hole on top of the stove. Put the connection pipe of the
stove into the back flue opening of the stove. Push the stove in place. Make sure that the
connection pipe goes well to the opening made in the chimney. Insulate
the empty space between
the connection pipe and the chimney with flexible, fireproof material such as stone wool . The lead-through
is tidied up with a Kastor covering plate, which is available at hardware stores. The covering plate is
fastened to the brick chimney with metal brackets or fireproof paste
.
2.5.4. Connecting from the top (all models)
In JK and KSIL models the connection opening is the one on the side of the door.
In normal models the connection opening is the one on the side of back wall.
Make an opening into the brick chimney that is 2–3 cm larger than the connection pipe.
Use a bent pipe for the connection from the top of the stove, which can be turned to align with the
chimney. Suitable bent pipes are available at the hardware store. Extend the bent pipe with an
extension piece, if necessary. Install the stove’s own connection pipe in the flue opening on top
of the stove. The bent pipe is then attached to the stove’s own connection pipe. Saw the bent
pipe and any extension pipe down to a suitable size where necessary. Make sure the pipe
extends sufficiently into the chimney (but not so far that it blocks up the chimney).
Seal the empty space between connection pipe and chimney with flexible, fireproof material such as stone
wool. The lead-through is then tidied up with a covering plate, which is available at your hardware store.
The covering plate is attached to the wall with metal bolts or fireproof paste.
2.6. Connecting to a Kastor or Helo chimney
In JK and KSIL models the connection opening is the one on the side of the door.
In normal models the connection opening is the one on the side of back wall.
Chimney sizes Saga 20 100mm and Saga 27 130mm
The stove can be connected from the top to a factory built Kastor chimney.
Make sure to choose the correct chimney type with regard to your stove mode, chimney height, exterior
circumstances, temperature class T 600 etc. For best results we recommend that you install a chimney
valve, as well.
•
Install a non-insulated connection pipe and any necessary extension piping on top of the
connecting pipe. Where necessary, saw the connection pipe and the extension pipe down
to suitable size.