Sharp SJ-F95PEBE - Инструкция (Страница 12)

12
INSTALLATION
1. To ensure adequate ventilation for your refrigerator, it is
recommended to provide space of 6cm on both sides
and at the back, and space of 9cm above the refrigerator.
Insufficient spacing will decrease the cooling efficiency,
resulting in unnecessary consumption of electricity.
2. Using the two front Adjustable feet, ensure that the
refrigerator is positioned firmly and level on the floor.
3. When right and left doors are not properly aligned,
adjust using the adjustable feet.
4. Remove the 4 screws of the cabinet lower part, and
then set the foot cover (supplied inside the refrigerator
compartment) with removed 4 screws.
NOTE:
• Position your refrigerator so that the plug is accessible.
• Keep your refrigerator out of direct sunlight.
• Do not place next to heat generating appliance.
• Do not place directly on the ground.
Provide suitable stand.
• To insert the power plug when the door is opened, door
alarm sounds but it is not abnormal. This sound stops
when closing the door.
When transporting
• Using the casters, it is possible to move back and forth.
• Carry the refrigerator by holding the handles located on
the rear and bottom.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly.
Adjustable foot
Lower the right side. Lower the left side.
(Until the adjustable foot on the
other side is slightly off-ground.)
When the left door is raised. When the right door is raised.
Screw
(4 screws)
Screw
Foot cover
Casters
(A713)_Eng.fm Page 12 Tuesday, April 11, 2006 9:16 AM