Инструкция по эксплуатации Sony PSP-1008
Страница 8
8
Precautions
may be displayed. Only connect to a personal access point that you are
authorised to use, or one that is available through a public wireless
LAN or hotspot service.
When travelling note any applicable wireless regulations.
If the PSP™ system or UMD
®
is brought directly from a cold location
to a warm one, moisture may condense on the lens inside the system or
on the UMD
®
. Should this occur, the system may not operate properly.
In this case, remove the UMD
®
and turn off and unplug the system. Do
not put the UMD
®
back in until the moisture evaporates (this may take
several hours). If the system still does not operate properly, contact the
appropriate PSP™ customer service helpline which can be found
within every PSP™ format software manual.
• Do not touch the opening on the rear of the disc (recorded surface of
the disc) with your fingers.
• Do not allow dust, sand, foreign objects or other types of dirt to get
on the disc.
• If the UMD
®
becomes dirty, gently wipe the exterior and recorded
surfaces of the UMD
®
using a soft cloth. Do not use solvents or other
chemicals.
• Do not use a UMD
®
that is cracked or warped or has been repaired.
The UMD
®
may break inside the PSP™ system, leading to injury or
malfunction.
Follow the guidelines listed below to help avoid deterioration or
discoloration of the PSP™ system:
• Do not use solvents or other chemicals to clean the exterior surface.
• Do not allow the system to remain in direct contact with rubber or
vinyl products for an extended period of time.
• Do not use a chemically-treated cleaning cloth to wipe off the
system.
For best results, go to
(Settings)
(System Settings) and
then with the "System Information" screen displayed, rotate the analog
stick in a circular motion. This will adjust the analog stick's range of
movement.
For safety reasons, unplug the AC Power Cord from the electrical
outlet and remove the Battery Pack from the system before cleaning.
Cleaning the exterior surface and LCD screen
Wipe gently with a soft cloth.
Cleaning the connectors
If the headphones or remote control connectors become dirty, this
could cause noise or interruptions in sound. Wipe the connectors with
a dry, soft cloth to keep in clean condition.
Overseas use
Moisture condensation
UMD
®
handling
Use and handling of the system
Before using the analog stick
Cleaning