Sony PSP-1008 - Инструкция (Страница 17)

17 Before requesting service
T
rou
b
les
ho
o
tin
g
GB
The system or AC Adaptor is warm.
, During use, the system or AC Adaptor may become warm. This is
not a malfunction.
The system is turned on, but does not operate.
, Check that the system is not in hold mode. If it is, slide the
POWER/HOLD switch up to clear hold mode.
, Try sliding the POWER/HOLD switch up and holding until the
POWER indicator turns off. The system will be completely turned
off. Then turn on the system again.
The system does not function properly.
, Static electricity and other similar occurrences may affect the
system's operation. Remove the Battery Pack and AC Adaptor,
wait for about 30 seconds and then restart the system.
When the buttons are pressed, there are no key tones.
, If "Key Tone" under
(Sound Settings) is set to "Off", no sound
is produced.
The date and time are reset.
, If the battery is not recharged and runs out, or if the Battery Pack
is replaced, the system date and time settings may be reset. Follow
the on-screen instructions to set the time and date.
The PSP™ system is not recognised by the PC when
connected using a USB cable.
, When using a USB hub or other devices, depending on the
operating environment of the PC, the Memory Stick Duo™
inserted in the system may not be recognised by the PC. Try
connecting the system directly to the PC using a USB cable.
You forgot your password.
, If you restore default settings under
(System Settings)
"Restore Default Settings", the system password will be reset to
"0000". For details, refer to the User's Guide (
page 4).
Note that if you restore default settings, settings you have adjusted
for options other than the system password will also be cleared.
Once cleared, these custom settings cannot be restored by the
system.
Other issues