WORX Tools WU601.1 - Инструкция (Страница 13)

Router ENG
router.
• Insert the guide rods (C) into router base. For
maximum stability, make sure each rod goes
through both holes and protrudes out the other
side of the router base (At a maximum, the rods
must be inserted far enough into the router
base that they are supported from below base.
• Securely fasten the router to the rods by
tightening the locking screws (12). The largest
circles and arcs can be made when the guide
rods enter the side of the router where the
locking screws (12) are located.
• Mark the workpiece at the center of the desired
circle.
• Using the centering slots on the edge of the
pivot plate (22), center the pivot plate on the
center mark and attach to the workpiece with
several strips of strong tape placed over the
pivot plate in a crisscross pattern.
• Place fine adjustment guide (F) on pivot plate
(22) so the hole in fine adjustment guide (F) fits
over the steel pin.
• Adjust the position of the rods and router as
necessary to achieve the desired radius of the
circle or arc, then securely tighten wing knobs.
13. CARBON BRUSH REPLACEMENT
Always be sure that the tool is switched off
and unplugged before attempting to perform
inspection or maintenance.
There are 2 motor brushes which can be easily
accessed on either the front or back of the
motor housing.
ATTENTION:
When servicing a tool, ALWAYS use only
identical replacement parts.
STEP 1: Locate the plastic motor brush caps on
both the front and back of the motor housing.
STEP 2: Remove the threaded access cap on
accessible carbon brushes (30) with a flathead
screwdriver and turn the screw in a counter-
clockwise rotation to loosen.
STEP 3: Gently remove the old motor brush.
STEP 4: Carefully insert the replacement brush.
Ensure the brush is completely inserted into
the holder and is seated properly and is free to
move inside its holder.
STEP 5: Replace the access cap with the flat-
head screwdriver, turning clockwise to tighten.
Do not apply excessive force as this may
damage the access plug.
Note: Always change both sets of brushes at
the same time.
MAINTENANCE
Your power tool requires no additional
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never
use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working
controls free of dust. If you see some sparks
flashing in the ventilation slots, this is normal
and will not damage your power tool.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or retailer for
recycling advice.
WARRANTY STATEMENT
If your WORX product becomes defective due
to faulty materials or workmanship within the
specified warranty period of:
• 12 months from the date of purchase.
We guarantee to repair or replace all defective
parts free of charge, repair products subject
to fair wear and tear, free of charge, or at
our discretion,replace the unit free of charge
to ensure minimum inconvenience to the
customer. Your warranty is subject to the
following conditions:
• Proof of purchase date and a valid receipt is
produced.
• The product has not been misused.
• Unauthorized persons have not attempted
repairs.
• The product has not been used for hire
purposes.
• The product has not sustained damage
through foreign objects, substances or
accidents.
• Damage is not a result of fitting non-approved
UKR-WU600 WU600.1 WU601 WU601.1-M-060726.indd 13 2006-7-26 14:08:54