English, Auto stop, Spray – Инструкция по эксплуатации Binatone SI-5000
Страница 7: Self-cleaning
7
77
77
ENGLISH
!
While holding the iron in a vertical position, aim its sole plate
towards the articles to be ironed and push the Select Knob (7)
(7)
(7)
(7)
(7)
to produce a directional strong burst of steam from the sole
plate. Push the button several times with 5-7 seconds intervals
until the article is fully refreshed. If during the process your
water tank (5)
(5)
(5)
(5)
(5) runs out of water, disconnect the appliance from
the mains outlet, refill the tank and plug the appliance back
into the power supply and continue the process.
Spray
Turning the Select Knob (7)
(7)
(7)
(7)
(7) to the position water spray « »
will help when ironing details of the article (cuffs, trimmings, plackets,
etc) or clothes, which demand low temperature ironing, when steam
ironing is not possible. Push the Select knob (7)
(7)
(7)
(7)
(7) several times to
moisten the material.
Self-Cleaning
Your iron has a self-cleaning function, which allows you to clean
the internal parts of the appliance from scale or dust. To use this
function perform the following procedure:
1. Turn the Select knob (7)
(7)
(7)
(7)
(7) to the position « ».
2. Fill the tank (5)
(5)
(5)
(5)
(5) with water to the «Max
Max
Max
Max
Max» level.
3. Place the iron in a vertical position and plug it into the mains
supply outlet.
4. Set the Fabric Setting indication (9) to «ËÅÍ» position (see
Figure B) and let iron heat until indicator light (10) stops
blinking.
5. When the iron reaches the maximum temperature, the indica-
tor light (10) will stop blinking. Set Fabric Setting indication
(9) to «РЕЖИМЫ» and «
» position.
6. Whilst holding the appliance horizontally over a sink, turn the
Select Knob (7)
(7)
(7)
(7)
(7) to the «SELF-CLEAN
SELF-CLEAN
SELF-CLEAN
SELF-CLEAN
SELF-CLEAN» position. Hot steam
will discharge from the sole plate (11)
(11)
(11)
(11)
(11) removing the scale and
dust.
7. If the blast of steam becomes weaker, repeat steps 4-6 several
time. When the water tank (5)
(5)
(5)
(5)
(5) is completely empty, turn the
Select knob (7)
(7)
(7)
(7)
(7) to the position « ».
8. Put the appliance into a vertical position and re-heat the iron.
9. To complete the cleaning process; Iron a piece of a clean old
cotton cloth in order to clean the sole plate (11)
(11)
(11)
(11)
(11) of any remain-
ing dust and scale and to evaporate the remaining water. When
you have finished ironing, always switch the appliance off and
disconnect from the electrical supply.
Auto stop
For safety reasons, your iron will automatically stop heating if
it’s left:
!
upright for 8-10 minutes, or
!
flat for 30-35 seconds.
The Color Changeable indicator (10)
(10)
(10)
(10)
(10) will slowly blink, at the
same time, the buzzer will beep six times. The iron will heat up
again when you move it and the operation light will stop blinking.
!
To deactivate automatic shut off, stand iron on heel or shake
gently, then the iron will switch on again.