Sony Handycam MSAC-SR1 - Инструкция (Страница 9)

9
-EN
Removing the “Memory Stick”
Make sure that the processing lamp goes off, and
press the eject button. The “Memory Stick” ejects.
Press the eject button.
Note
The processing lamp
lights while data is
transferred between
the “Memory Stick”
and the PC. While
transferring data, do
not remove the
“Memory Stick”.
Doing so may
damage the data.
Precautions
• If the AC power adaptor or the serial cable is
disconnected while transferring data between the
“Memory Stick” and the PC or while displaying a
picture on the PC, data transfer will be stopped.
If the AC power adaptor becomes unplugged, exit the
PictureGear 3.2Lite software, remove the “Memory
Stick” and re-plug in the AC power adaptor. Then,
restart the software and perform the transferring
procedure.
If the serial cable is disconnected, exit the PictureGear
3.2Lite software, unplug the AC power adaptor, connect
the serial cable firmly and then re-plug in the AC power
adaptor. After that, restart the software and perform the
transferring procedure again.
• If data transfer still cannot be performed successfully,
disconnect and reconnect the serial cable connector on
the MSAC-SR1 or unplug and re-plug in the AC power
adaptor.
Processing lamp