Elenberg LVD-1502 - Инструкция (Страница 83)

83
SOLVING PROBLEMS (TROUBLESHOOTING)
SYMPTOM CHECK ITEM
DVD player doesn’t
play.
Make sure a disc is loaded.
Make sure the disc is not loaded incorrectly.
Make sure disc is not dirty, warped or scratched.
Make sure the player’s region code is the same as region
code of DVD disc you’re playing.
Make sure water condensation has not occurred. If
occurred, take out disc and leave the player on for at least
one hour.
There is no sound.
Make sure system connections are correct.
Make sure the sound setup of DVD disc is correct.
Make sure disc is not dirty, warped or scratched severely.
Clean or replace the disc.
Make sure the speaker mute is not on.
In the TV mode, set the correct sound mode.
LCD is no display
Make sure the unit is turned on and connections are
correct.
Make sure the power adapter is correctly connected.
Cannot continue
play or play a section
repeatedly.
Make sure DVD it is not in repeat status.
Make sure disc is not dirty or damaged.
There is no picture
or picture is
intermittent.
Check if the connections with the external A/V signal
source are correct and solidly connected.
Correctly set the functions in the picture menu.
Check if the video input signal is corresponding to the unit
being used (type o input source).
Make sure the unit is turned on and the correct video type.
In VGA mode make sure the resolution is correct.
Remote control not
working.
Make sure there are no physical obstructions between the
remote control and the player such as plants, furniture, etc.
Make sure the remote control is pointing at the player.
Make sure batteries are inserted and the polarity is correct.
Make sure batteries are not weak. (needing replacement)
PLEASE NOTE: PLEASE NOTE:
Electrical static or other external interferences may cause the player to behave ab-
normally. If this occurs, unplug the power-supply from the outlet and plug it in again
to reset the player. If problems persist, disconnect the power and consult a qualifi ed
service technician.