Main technical data programme summary / selection – Инструкция по эксплуатации Elenberg DW-600
Страница 22
allowed to open after pressing the pause button. At the beginning of each cycle,
the dishwasher always starts in the “drain” mode. This is because the drain
pump always retains a small amount of water (in the sump) from the previous
cycle. This is necessary to keep the pump primed. Therefore, do not be alarmed
if you see a small amount of water being pumped-out from the drain hose prior
to the start of the regular wash cycle (THIS IS NORMAL).
CLEANING YOUR DISHWASHER AND FILTER
After each wash cycle unload the dishwasher, remove the filter, clean off any bits of
food, by placing the filter under a running cold water tape please ensure that the
filter is replaced back into the correct position before you next wash.
INTENSIVE WASH
Water Temperature
Wash 65°C / Rinse 69°C
Programme Duration + Heating Time
129 minutes
Water Consumption
10,4 litres
NORMAL WASH
Water Temperature
Wash 52°C / Rinse 67°C
Programme Duration + Heating Time
130 minutes
Water Consumption
10,4 litres
RAPID WASH
Water Temperature
Wash 49°C / Rinse 55°C
Programme Duration + Heating Time
60 minutes
Water Consumption
9,6 litres
Model
DW-600
Power input
1380W
Outer dimension
570 x 480 x 466mm
Weight
About 22.5kg
Max. water Consumption (Normal wash)
10,4 L
Water pressure
0.03~1MPa
Control manner
Automatic
Detergent dosage
12g
Plate setting
4 sets
MAIN TECHNICAL DATA
PROgRAMME SUMMARY / SELECTION