Water pressure disconnecting your dishwasher – Инструкция по эксплуатации Elenberg DW-600

Страница 18

Advertising
background image

1

6. If for any reason you are unable to stop the leak yourself please seek advice

from a qualified plumber.

7.

The minimum height clearance required to install your dishwasher on a countertop
surface with overhead cupboards is 19” (48cm).

8. Make sure there is an electrical power supply within easy reach of the machine.

The power cord is 6 feet (182.8cm) long.

9. The dishwasher must be installed on a ‘solid’ level surface.
10. To level the dishwasher, adjust the 4 level screws (feet) under the dishwasher.

For best operating results, incoming water pressure should be between 0.3 and 10
bar.
FOR BEST RESULTS:
• Your dishwasher cleans by spraying a mixture of hot clean water and detergent

(under pressure) against the soiled surface of dishes. The water is pumped
through a rotating spray arm, drained through a filter removing food and soiled
particles and pumped back through the spray arm.

• Soiled water is pumped out and replaced with clean water at the end of each cycle

(the number of times depends on the cycle being used). For best cleaning results,
the water temperature must be at least 55

0

C. To prevent dishwasher damage, the

temperature of the incoming water supply should not exceed 60

0

C.

NOTE: Hard Water conditions will adversely affect wash ability performance of

your dishwasher. Hard Water conditions will also contribute to “Lime” (white
film substance) deposits and/or “Scaling” on the stainless steel surface of the
dishwasher tub and “Heater Element” located in the sump underneath the
removable filter screen. To assist in minimizing these conditions, it is recommended
to periodically operate/rinse the inside of the dishwasher (empty) using 1 cup of
white vinegar (at least once a week).

• Close the hot water supply at the stopcock.
• Disconnect the power supply cord.
• Disconnect the inlet hose assembly from the water supply. When the dishwasher

is not in use, place/store the hose on the hanger hose bracket located on the rear
wall of the dishwasher cabinet.

• Appliances that are to be discarded must be made unusable. Pull off the plug,

remove cable and make the door lock and latch unusable

IMPORTANT

Once you open the water supply line, (even if it is closed immediately there after)
the water inlet hose will be pressurized.

CAUTION

DO NOT LET CHILDREN DISCONNECT THE DISHWASHER. Close supervision
of children is always important around appliances.

WATER PRESSURE

DISCONNECTINg YOUR DISHWASHER

Advertising