Saturn ST-HC7387 - Инструкция (Страница 2)

2 3
GB
HAIR CLIPPER
Dear Buyer!
We congratulate you on having
bought the device under trade name
«Saturn». We are sure that our de-
vices will become faithful and relia-
ble assistance in your housekeeping.
Avoid extreme temperature changes.
Rapid temperature change (e.g.
when the unit is moved from freezing
temperature to a warm room) may
cause condensation inside the unit
and a malfunction when it is
switched on. In this case leave the
unit at room temperature for at least
1.5 hours before switching it on.If
the unit has been in transit, leave it
indoors for at least 1.5 hours before
starting operation.
READ ALL INSTRUCTIONS BEFORE
USING AND SAVE THESE INSTRUC-
TIONS
BLADE ALIGNMENT
· Your clippers were carefully ex-
amined to ensure, that the
blades were oiled and aligned
before leaving our factory.
· Blades must be realigned, if they
have been removed for cleaning
or replacement.
· To realign the blades, simply
match the upper and bottom
blades teeth up, point for point.
(End of top blade teeth should be approx-
imately 1.2mm back from bottom blade;
compare your clipper blades with the
sketch).
· If blade alignment is incorrect,
add a few drops of oil to the
blades, turn clipper on for a few
moments, turn off and unplug.
Loosen screws slightly and ad-
just. Tighten screws after blade
is aligned.
OIL
· To maintain your clipper in peak
condition, the blades should be
oiled every few haircuts.
· Do not use hair oil, grease, oil
mixed with kerosene or any sol-
vent, as the solvent will evapo-
rate and leave the thick oil,
which may slow down the blades
motion.