Инструкция по эксплуатации Saturn ST-CC7107
Страница 3
Preparation for Use
Filling the water tank
l
Make sure the iron is switched off.
l
Carefully remove the water fill cov-
er.
l
Using a small cup, carefully fill the
iron up to the maximum level,
never overfill
l
Replace the cover.
l
If the water in the local area is
hard we recommend using 50%
distilled water and 50% tap wa-
ter.(never use only distilled water)
Setting the Temperature
l
Put the iron on its heel
l
Set the required temperature by
rotating the dial until the desired
setting is obtained, check the sew
in label in the clothing to deter-
mine the material used.
-
● Synthetics, acetate, acrylic, poly-
imide, nylon, polyester, viscose
-
●● Silk
-
●●● Cotton/Linen
l
Note: The iron is only intended to
produce steam on the ●●● setting
l
Now plug in the iron and wait for
the indicator light to go out, the
iron is now ready to use.
l
If required extra steam can be
generated using the steam burst
button.
Trouble Shooting
Problem
Possible
Cause
Solution
The iron
is
plugged
in but the
soleplate
is cold
There is a
connection
problem
Check the
plug is in-
serted into
the wall
socket
The tem-
perature
setting has
been set to
off
Set the
temperature
setting to
the required
temperature
The iron
does not
produce
steam
There is not
enough wa-
ter in the
tank
Refill the
reservoir
The tem-
perature
setting is
not set to a
steam posi-
tion
Rotate the
temperature
dial to the
required
setting
Water
leaks
from the
soleplate
The tem-
perature is
not hot
enough
Rotate the
temperature
dial to the
required
temperature
for steam
and wait
until the
light goes
out
Flacks
and im-
purities
come out
of the
soleplate
during
ironing
You have
been using
water which
is too hard
Fill the res-
ervoir with
50% dis-
tilled water
and 50% tap
water.
Switch on to
the hottest
temperature
and wait for
the light to
go out.
Holding the
iron over a
sink press
the extra
steam but-
ton a few
times, this
should flush
the flake out
of the iron.
Turn off and
allow to
cool, then
wipe the
soleplate
several
times with a
damp cloth
to remove
any resi-
dues.
Specification
Power:
800 W
Rated voltage:
220-230 V
Rated frequency:
50 Hz
Rated current:
3.5 A
Set
Iron
1pc
Instruction manual
with warranty book
1pc
Package
1pc
Environment friendly disposal:
You can help protect the environ-
ment!
Please remember to re-
spect the local regula-
tions: hand in the non-
working electrical equip-
ments to an appropriate
waste disposal centre.
The manufacturer re-
serves the right to
change the specifica-
tion and design of goods.
4
5