Beko M 5604 CTX RU - Инструкция (Страница 42)

4.^ Oporating the hot platos
Corr*<ftaiMfHt9 Cocking Vtthi»t
Hofp/ofe contrai position I 2 1 3 4 \ 5 \ 6
Applicafian W arm ing Sim m ering Cooking-Frying-Búiiing
A rapid heating hotplate is denoted by a red spot
in the centre of the hotplate:
Hotplate operating knobs
The knobs for the hob
can be rotated in either
direction
to provide fully variable beat control.
When any one of the hotplates is on, the red
indicator light on the control panel will be on.
In order to switch the hotplate OFF turn the
corresponding knob to the 0 (zero} position. Knobs
of the hotplates can be turned both clockwise and
counter-clockwise directions.
Ch0cfc that all tha tookar controls hava
been swffcbed oft offer use.
Adjust the hotplates to mid position (3j and leave
on for approximately 8 minutes in order to burn
off the protective coating
on
the hotplates. Do not
place any pans or other cooking utensil on the
hotplates during this
process. Fumes
will be emitted
during the above operation but this is quite normal.
Good Quality Pans
«■ Use
only good quality pans having a stable bottom
os
shown below. This
results in the maximum use of energy.
»■
Use pans for the
correcf
diameter
only. If the pan is too small
energy
is
wasted.
Do nof
place pans with wet bases
or pan lids particulary wet lids on the
hotplates damage could occur and
safety problem will be experienced.
Hotphts diameter Suggested diameter
(mm¡ of the pan (mmj
0 ]45 m m (Smaii) ------------ ►Н50-Н70
0 t S O m m (Large} ---------- ►Í80-200
••
Drying the hotplates (max 5 min).
when cool;
Clean off solid hotplates with a damp cloth and a little domestic cleaning
cream. After
cieoning,
dry solid hoplates by switching on for a short time. Apply
a thin coat of cooking oil from to time.
When wiping the hotplates with
o damp
cloth follow the circular grooved
pattern on the hotplate.
8