Beko CG 41010 G - Инструкция (Страница 39)

Part T:
Gas converfffon
Your cooker can operate both
Natural Gas and LPG. You can
convert by changing the gas
source and the top burner, oven
and grill injectors. The
replacement procedure of the
injectors are explained below.
Call authorized Service for gas
convertion.
Replacement of the fop
burner injector
Take off the burner head
and burner cap before
starting this procedure.
Then:
1. Remove the injector
inside the top burner with
a suitable bit. Later, install
the new injector by covering
the injector threads
with leakage
preventing
material. Flame failure
Reduted Tap Flew
Removal of the control panel
L Open the front door.
2.
Unscrew the two screws of the
control panel and take the control
panel bottom sheet.
3.
Release the control panel from the
two notches at the top, slightly pull
it to the bottom front and keep if free
with its cables connected.
Ignite the burner that should be
adjusted, turn the knob to the reduced
position, pull and take the knob off.
4. With a screwdriver, make the tap
reduced flow adjustment from the
injector that is on the gas tap (only
the head is visible with the bolt
shape).
It is sufficient to tight to screw
completely, in butane/propane gas.
For the natural gas, you should turn
the screw counter-clockwise
once. The normal length of a straight
flame in the reduced position
\
should be 6 - 7mm.
If the flame is higher than the desired
position, turn the screw clockwise. If
its smaller to the opposite.
For the last control of the burning of
the cooker, bring the cooker high-
flame and reduced positions and
check whether the flame is on or off.
16