Part 4* operating the top burners, Operating the top burners, Part 4 – Инструкция по эксплуатации Beko CG 41010 G
Страница 29
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
Part 4*
Operating the top burners
I 30
cm
33
cm
To obtain maximum
etti€ion€y
A correct use to burner
results in gas saving and
better out put. Therefore we
recommend to use
saucepans whose base
completely cover the
flames. Four saucepans
with much smaller
diameters to be put
auxiliary burner^use the pan
support adaptor.
Flame failure
device
0
if your cooker has fíame
iaiiure cfevice on gas burners/
In case of any flame failures
with any reasons in the top
burners, the flame failure
^ device immediately cuts of
r .
s
the gas flow. It is also a safety
device for the wrong use of
the children.
You
should
turn
the
knob
to
the
clockwise
direction
by
pressing.
You
should
ignite
by
pressing
the
knob
and
wait
for
its
ignition.
You should keep the knob at pressed position
for
3-5
seconds
after
you
see
the
flame
around
the
burner.
Repeat
the
sequence
of
operations if the flame does not continues.
6
Use of fop gas burners
Turn the relevant knob by slightly
pressing in counter clockwise direction.
The large flame on the knob
corresponds to maximum capacity
position and the small flame
corresponds to minimum capacity
position.
Ignition by kvffon
(In models with ignition}
If provides automatic ignition.
When the button is pressed and released
all plugs spark at the same time. The
ignition starts at the burner through which
the gas flows. If an ignition does not occur,
repeat the same action. Holding the button
at pressed position does not provide
ignition.
After you release the knob, if the ignition
does not continue repeat the same
process by keeping the knob pressed
for 15 seconds. If still no ignifon occurs,
wait for
1 minute
and repeat again.
Warning : Do not keep the knob in
pressed position more than 15 seconds.