Petsafe Big Cat/Small Dog Pet Door - Инструкция (Страница 54)

54
www.petsafe.net
FI
SV
DA
NO
RU
EN
Before installing your pet door
please read the following step-by-
step instructions carefully.
Tools required
• Pencil
• Ruler
• Jig or Keyhole Saw
• Drill
• 13 mm ( 1 /
2
”) drill bit
• Screwdriver
• Tape measure
• Sand paper
• Scissors
• Hacksaw or screw cutter
• Silicone adhesive (optional)
• Duct tape (optional)
Measurement and marking
Measure the belly height of your pet (x). This is usually 100 mm to 150 mm ( Fig.1).
Mark this measurement on the outside of your door and draw a straight
horizontal line ( Fig. 2).
Please bear in mind that this line is eventually where the
bottom of the hole you cut in your door will be. The frame of
the pet door will be slightly lower. If necessary, this line may
have to be raised slightly to account for this.
When applying cutting template there should be a minimum of 75 mm
between the bottom and sides of the door and the outer edge of the
cutting template to maintain the structural integrity of the door.
FIG. 1 FIG. 2
Cutting a hole for your pet door
a) In Wood and PVC/uPVC/Metal
The pet door requires a cut-out with
a width of 228 mm (
Fig. 3).
(x)
(x)
Not to scale - for best results you should
refer to the enclosed cutting template.
228 mm
FIG. 3
Wooden doors
PVC/uPVC/Metal