Cassette tape recording – Инструкция по эксплуатации SoundMax SM-2402
Страница 6
6
• Press the STOP/EJECT button to stop the playing, press the button again to open the cassette door and you
can take out the tape.
• Press the "STOP" button followed by the REWIND or FORWARD button to rewind or forward the tape at
high speed.
Cassette tape recording
• Open the cassette door by pressing the "STOP/EJECT" cassette button.
• Insert a blank cassette with the tape-side up, into the proper Guide-rails on the inside of the cassette door.
• Gently push the cassette door forward (inwards) to close it.
• Make sure the tape is fully and properly inserted before doing so.
• The set is now ready to start recording, which can be done from either the radio or CD-player.
Recording from radio
• Set the FUNCTION switch to RADIO position.
• Tune to the desired station.
• Press the PLAY button and RECORD button on deck simultaneously to start recording.
• Press STOP/ EJECT button to end recording
Recording from CD
• Set FUNCTION switch to CD/MP3 position.
• Press RECORD and PLAY buttons on cassette deck simultaneously to start recording.
• Press the PAUSE button on deck.
• Start the CD-player and select the exact song to be recorded.
• Release the PAUSE button on deck to start recording.
• Press STOP/ EJECT button to end recording.
Erase protection
• To prevent accidental erasing of a cassette, simply break off the two plastic tabs located
on the cassette tape’s rear side.
• When a cassette with removed plastic tabs is inserted, the recording button cannot be
pressed.
• If a cassette is to be erased and re-recorded at a later stage, simply cover the holes on the
cassette where the tabs were removed, with a piece of strong adhesive tape.