Vitek VT-3456 - Инструкция (Страница 5)

8
CAUTION
To avoid damage to the cassette mechanism or to the cassette tapes, always press the STOP/EJECT Button between
each operation!
RECORDING FROM THE RADIO
1. Tune to a desired radio program as described in the "RADIO OPERATION" section.
2. Insert a blank cassette tape into the CASSETTE COMPARTMENT.
3. Press the PAUSE BUTTON.
4. Press the RECORD BUTTON. The PLAY BUTTON is engaged simultaneously to start recording. With the built in
Automatic Level Control (ALC), the best recording quality is automatically adjusted. Changing the volume level will not
affect the recording.
5. To stop recording temporarily, press the PAUSE BUTTON. To continue the recording, press the PAUSE BUTTON once
again.
6. Press the STOP/EJECT BUTTON to stop recording.
7. When the tape runs to its end, the cassette operation will be stopped automatically.
MIC JACK (3.5MM)
Connect Dynamic hand microphone (not supplied) to MIC JACK for Mic recording.
CD OPERATION (CD R/RW PLAYBACK COMPATIBLE)
PLAYING COMPACT DISC
GETTING STARTED
NOTE: Should skipping of tracks occur during CD playing, try turning the volume down.
When CD is playing, do not open the CD Door.
1. Open the CD DOOR by pull up the CD DOOR. Put a CD into the CD COMPARTMENT and close the CD DOOR. Set the
FUNCTION SWITCH to "CD" position.
2. When the CD DOOR is closed with a CD inside, the total number of tracks of the disc will be shown on the CD LED DIS
PLAY and will go to "STOP" mode.
3. If the CD DOOR is not closed or there is no disc inside, the DISPLAY will show " 0 0 " and go to "STOP" mode.
PLAY/PAUSE MODE
1. When the PLAY/PAUSE BUTTON is pressed during "STOP" mode, the first track will be played. The PLAY/PAUSE LED
INDICATOR will be lighted. The CD LED DISPLAY will show the specific number of track being played.
2. For interruption while the CD is playing, press the CD PLAY/PAUSE BUTTON once. The PLAY/PAUSE LED INDICATOR
will flash continuously.
3. Though the sound stops, the disc will continue to spin. To re start playing, press the CD PLAY/PAUSE BUTTON once
again. The music will start from the exact position where it was interrupted.
4. To stop the CD, press the CD STOP BUTTON once whether the CD is in Play or Pause mode.
REPEAT MODE
1. REPEAT 1:
When the REPEAT BUTTON is pressed once, the REPEAT LED INDICATOR will light and flash continuously. This single
track of music will be repeated.
2. REPEAT ALL:
When the REPEAT BUTTON is pressed twice, the REPEAT LED INDICATOR will stay lit. The whole disc can be played con
tinuously.
3. TO CANCEL THE REPEAT FUNCTION
Press the REPEAT BUTTON until the lighted REPEAT LED INDICATOR is turned off .
SKIP AND SEARCH MODE
1. During play or pause mode, when CD SKIP FORWARD ">>" or CD SKIP BACKWARD "<<" Button is pressed once, it
will go to the next track or go back to the beginning of the track.
2. During play mode, when CD SKIP FORWARD ">>" or CD SKIP BACKWARD "<<" BUTTON is pressed and held, it will
search the track with audible high speed forward or backward playback.
PROGRAM MODE
1. During the CD STOP mode, press the PROGRAM BUTTON once. The PROGRAM LED INDICATOR will light up and blink
continuously while the CD LED DISPLAY will show the number of Program to be memorized starts from first program "01"
and blink continuously as well. Press the CD SKIP FORWARD ">>" or CD SKIP BACKWARD "<<" BUTTON to your desired
musical track, the CD LED DISPLAY will show the appropriate track number. Press the PROGRAM BUTTON to store the
desired track in memory.
5
ENGLISH РУССКИЙ
3456.qxd 22.09.03 14:58 Page 10