Binatone Active XA2020 - Инструкция (Страница 8)

8
[31] cable plug into its jack [30] at the charger [29] rear side
and plug the AC adapter [31] into a wall outlet of your 220V
electric mains (see Fig. E).
4. Attach the belt clip [22] to the handset by aligning it with the slots
[23] on the handset (see Fig. C).
5. Place the handsets [1] and [33] (only Twin XA2020) on the base
unit [13] and the battery charger [29] (see Fig. B, E). Before initial
use you should fully charge the battery, so charge it for about 15
hours. When you place the handset [1] on the base unit [13] for
charging and (only for Twin XA2020) the handset [33] on the
charger [29], you should hear a short beep and in so doing the
indicator lights [15] and [32] will light.
Notes:
1. When you are not using the phone (for example, when you are not
at home), place the handset on the base unit so that the battery is
always charged.
2. To ensure the maximum operating distance and noise-free
operation, install the base unit in a high location away from electrical
appliances such as a refrigerator, personal computer, TV or another
phone.
3. You can dial a phone number in pulse or tone mode. To choose the
appropriate mode, just slide the P-T switch [28] to “Tone” position for
Tone dialing and to “Pulse” position for pulse dialing.
The handset of the ACTIVE XA2020/ Twin XA2020 phones will not
operate in cases of a power failure. Therefore, in case of a power failure
you can use the Speakerphone mode of your base unit for essential
communications such as medical emergencies.
If you are moving during a conversation and noise interferes with
the conversation, this may be caused by some interference, the source
of which is located between the handset and base unit, for example,
you may be too close to another phone or other electric equipment.
Move to another location as far from the interference source as possible
and press the CH button [10]. If you not do this, the call may be
disconnected.
MAKING CALLS
Using the handset
Making calls
1. Press the PHONE button [3], the indicator light [2] lights.
2. Dial a phone number.
Answering calls
When the phone rings, press the PHONE button [3].
Note:
For noise-free calls, it is necessary to extend the antennas [11]
and [18] on the handset and base unit.
Finishing calls
To finish a call, press the PHONE button [3], the indicator light [2]
will go out.
Redialing the last dialed number
1. Press the PHONE button [3], the indicator light [2] lights up.