Speakerphone, 10 changing the ringer volume, Adjusting handset earpiece volume – Инструкция по эксплуатации Binatone Active XA2020
Страница 10: Changing the speakerphone volume, Making calls using the speakerphone, Answering calls using the speakerphone, Finishing calls, Redialing the last dialed number, Handset locator
10
Changing the ringer volume
1. Press the VOLUME/RINGER
button [7] (the ringer volume
cannot be changed during a call), the indicator light [2] lights up.
2. Press the
∗∗∗∗∗ button to increase the ringer volume, press the # button
to decrease the ringer volume.
3. Press the VOLUME/RINGER
button [7] once again, the
indicator light [2] goes out.
Adjusting handset earpiece volume
During a call you can adjust the handset earpiece volume. To do
this, press the VOLUME/RINGER
button [7] during the
conversation.
Using the base unit
Speakerphone
Changing the Speakerphone volume
To change the speakerphone volume use the
control [17] on
the side of the base unit.
Making calls using the Speakerphone
1. Press the SPEAKERPHONE button [14], the indicator light [12]
starts to flash.
2. Dial a phone number using the dialing buttons [9] on the base unit.
Answering calls using the Speakerphone
To answer a call using the speakerphone, press the SPEAKER-
PHONE button [14], the indicator light [12] starts to flash.
Finishing calls
To finish a call, press the SPEAKERPHONE button [14], the indica-
tor light [12] will go out.
Redialing the last dialed number
1. Press the SPEAKERPHONE button [14].
2. Press the LNR/P button [6] and the last dialed number will be
automatically redialed. (You can redial a number consisting of no
more than 32 digits.)
Handset locator
1. To locate the handset, it is necessary to press the PAGE ))) button
[16] and in so doing the handset will beep.
2. To cancel the handset locator function, press the PAGE ))) button
[16] once again or press the PHONE button [3] on the handset.
Transferring a call from the base unit to the
handset
1. During a call in the Speakerphone mode press the PAGE ))) button
[16] on the base unit.
2. Press the PHONE button [3] on the handset to receive the call. The
base unit will automatically disconnect from the call.
Transferring a call from the handset to the base
unit
1. During a call using the handset press the SEC/HOLD button [4].