Vitek VT-1130 - Инструкция (Страница 6)

РУССКИЙ
7
CARE AND CLEANING
Always disconnect the kettle from the power outlet before cleaning.
Never immerse the kettle switch area, cord or power base in water, or allow moisture to
come into contact with these parts.
Removal of mineral deposits
Mineral deposits in tap water may cause the interior of the water gauge to discolour.
To remove this build-up, use Liquid Descaler, a simple to use, non-toxic cleaner available
from Appointed Service Agents.
Alternatively:
1. Fill the kettle with 3 cups of white vinegar and the remainder with water and allow to
stand overnight. DO NOT BOIL.
2. Empty the solution from the kettle. Fill the kettle with clean water, bring to boil and then
discard the water. Repeat and the kettle will then be ready to use.
To clean the polished exterior
The stainless steel surface may be wiped over with a damp cloth and polished with a soft
dry cloth.
CAUTION: Do not use chemical, steel wool, or abrasive cleaners to clean the outside of
the kettle, as these will scratch the stainless steel surface.
To clean the mesh filter
Press the button at the top of the handle to open the hinged lid. Grasp the top of the scale
filter and pull upwards to remove. Wash in warm soapy water and dry thoroughly before
replacing in the kettle.
Cleaning the concealed heating element
This kettle features a non-corrosive stainless steel heating element. Over time, scale may
build up on the concealed element inside the kettle, causing discolouration that may have
the appearance of rust. Be assured this is not rust. If this occurs clean with a green
Scotchbrite
® scourer or similar and a suitable abrasive cleaning cream. Rinse and clean
thoroughly with tap water before using your kettle again.
SPECIFICATION
Power requirement
220-230 V ~ 50 Hz
Max. power 2000 W
Max indication of water 1,8 L
The manufacturer reserves the right to change the characteristics of the
device without prior warning.
SERVICE LIFE OF THE CORDLESS KETTLE NOT LESS THAN 3 YEARS
ENGLISH
6
ОСОБЕННОСТИ ВАШЕГО ЭЛЕКТРОЧАЙНИКА С КОРПУСОМ ИЗ НЕРЖАВЕЮЩЕЙ СТАЛИ
1. Крышка чайника
2. Съемный сетчатый фильтр
3. Стильный дизайн корпуса
из нержавеющей стали
4. Закрытый нагревательный
элемент мощностью 2000 Ватт
5. Кнопка включения/выключения, открытия
крышки
6. Рукоятка с мягким покрытием
7.
Шкала уровня воды
8. Подставка, позволяющая вращать чайник
на 360°
9. Место для намотки и хранения
сетевого шнура
1130.qxd 09.07.2004 10:55 Page 10