Electrolux ESF2450S - Инструкция (Страница 15)

If the water inlet hose is too short, replace the
water inlet hose with an applicable, longer
high-pressure hose. Do not connect an ex-
tension hose.
To suit the installation, it is possible to turn
the end of the hose that is connected to the
dishwasher. Do these steps :
1. Loosen the retaining nut.
2. Turn the hose.
3. Tighten the retaining nut.
Warning! Make sure that the retaining
nut and all other connections are tight
before you move the dishwasher into
position.
Warning! Always use a new water inlet
hose. Do not use connection hoses from
an old appliance.
Drain hose
The appliance has water safety system to
prevent water damage. If there is a malfunc-
tion, the drain pump automatically starts to
drain the remaining water out of the dish-
washer.
Warning! Only if the dishwasher is
connected to the mains socket, the
water safety system operates when the
dishwasher is off.
2 procedures are possible to install the water
drain hose :
1. Attach the plastic curve supplied at the
end of the hose.
Put the water drain hose in the sink.
2. Connect the water drain hose to the wa-
ter drain system.
The hose must be less than 75 cm above
the bottom of the dishwasher to prevent
incorrect operation of appliance.
If you connect the water drain hose to a trap
spigot under the sink, remove the plastic
membrane (A). If you do not remove the
membrane, remaining food can cause a
blockage in the drain hose spigot
electrolux 15