ViTESSE VS-651 - Инструкция (Страница 4)

P/5 P/6
www.vitesse.ru
STEAM IRONING
Note:
1. Place the iron on a level, horizontal ironing board.
2. Set the steam control knob to “0” position, and then fill the reservoir with clean
tap water refer to above filling instruction.
3. Connect the appliance to a suitable power socket, set the temperature control
dial to ”MAX” position. The heating indicator light will light up, which indicate
that the unit is being heated up. When the required temperature is reached,
the heating indicator light will turn off.
4. For every first use, press down the Turbo Steam Button several times
continuously, and then press down the self-clean button for about 10 seconds
to clean the steam chamber.
5. Set temperature control dial to desired position according to different fabrics,
put the steam control knob to ” “ position, and then steam will come out from
steam vents of soleplate. During steam ironing, it is normal that the heating
indicator light cycle from ON to OFF and the OFF to ON. It is because the
appliance is automatically heat preservation.
6. When setting the temperature control dial on ” l ” or “ l l ” position, there are
no steam go out of the soleplate since the temperature of soleplate is so low
that it can not produce steam.
7. After use, turn steam control knob to “0” position, disconnect the appliance
from power socket.
8. Before storing, please allow the unit completely cool down.
1. It is normal that a “pong” sound produced, it because that the anti-drip function
is automatically activated.
2. Every first time use, the iron should be pre-heated for about 2 minutes. During
steam ironing stage, steam may be stopped escaping from the outlet resulting
from the anti-drip function being activated. Just to turn the steam control knob
to smaller steam position or temperature control dial to larger position, it will be
resumed again.
DRY IRONING
Note:
TURBO STEAM IRONING
Caution:
1. Place the iron on a level, horizontal ironing board.
2. Set the steam control knob to “0” position.
3. Fill reservoir with water as indicated in above filling instruction.
4. Connect the appliance to suitable power socket, and then set temperature
control dial to the desired position according to different fabrics. The heating
indicator light will light up, which indicate that the unit being heated up, When
the heating indicator light turn off, the required temperature is reached. It is
ready for dry ironing. 5.If water spray is necessary, press down the spray
button two or three times in quick succession, water can be sprayed evenly in
the fabric.
6. After use, turn temperature control dial to “Min” position, and disconnect the
appliance from main socket.
When changing your temperature control dial from higher settings to lower, it is
proposed that not to start ironing immediately since there may be any burns
caused on your fabrics by high temperature. Please wait for the indicator light
illuminate again and then start ironing.
The Turbo of Steam feature provides additional steam for removing stubborn
creases
1. Set the ”steam control knob” to “0” position, and then fill the reservoir with
clean tap water refer to above filling instruction.
2. Connect the appliance to a suitable socket outlet, set the temperature control
dial to ” MAX” position. The heating indicator light will light up, which indicate
that the unit being heated up, When the heating indicator light turn off, the
required temperature is reached.
3. Press the turbo steam button two or three times in quick succession to obtain
more powerful turbo steam.
4. It is normal that a small amount of water may be ejected from the sole-plate
when pressing burst steam button so frequently that temperature of sole-plate
will be down accordingly. It is supposed to stop pressing turbo steam button,
and allow it to heat up again.
5. After use, turn steam control knob to “0” position, disconnect the appliance
from power socket.
6. Before storing, please allow the unit completely cool down.
when using turbo steam ironing, should turn steam control knob to “0” position.